I designed a cylinder with cut outs so you could get to the coins easily. I also wanted to make it different by making it spin. So I added a base to it and had a hole in the bottom that would make it spin.
|
|
I made the main part shorter so I could print out what I needed without wasting filament. When I printed it out, I found that the hole in the bottom was going to be too small.
|
|
I redesigned the pieces and printed out the short main part again. This time nothing seemed wrong.
|
|
I printed out the base and put the short main part on it to see if everything was going to work. It did.
|
|
Then the main was printed out in full and stacked on top of the base. I took home the coin organizer and put my coins in it and now my coins aren't in a pile on my desk.
|
|